# Introduction

n recent years compact antenna with multiband characteristics is topic of interest for research work for application in wireless Communication system. One of the techniques to design a compact microstrip antenna [MSA] is cutting slots or slits on the radiating patch to increase the length of the patch of the surface current. Some articles on the design of compact MSA were studied by the author [1][2][3][4].MSAs are used in a broad range of applications from communication systems to biomedical systems, primarily due to several attractive properties such as light weight, low profile, low production cost, conformability, reproducibility, reliability, and ease in fabrication and integration with solid statedevices. The work to be presented in this paper is also a compact microstrip antenna by cutting two L slits on the right side of the patch [5][6][7]. Our aim is to reduce the size of the antenna as well as increase the operating bandwidth. The proposed antenna (substrate with ?r=4.4) presents a size reduction of 71.14% when compared to a conventional square microstrip patch with a maximum bandwidth of 48.56 MHz. The simulation has been carried out by IE3D software which uses the MOM method [8]. Due to the Small size, low cost and low weight this antenna is a good candidate for the application of EMPS and WiMax technology.


# II.


# Antenna Structure

The geometry of the square patch is shown in Figure1 which is a 20 mm x 20 mm. The antenna is fabricated on a substrate of FR4 epoxy with dielectric constant (?r) =4.4 and substrate height (h) =1.6 mm. Co-axial probe feed of radius 0.5 mm. 


# Simulated Results

In this section, various parametric analysis of theproposed antenna are carried out and presented. Several slit parameters have been investigated toimprove bandwidth, gain and return loss performance of the antenna. Optimal parameter values of the two L slits are listed in Table 1and 2.

Table 1:
Table 2 :
The simulated return loss of the conventional antenna (antenna 1) and the proposed antenna (antenna 2) are shown in Fig. 3   


# Experimental Results

Comparisons between the measured return loss with the simulated ones are shown in Fig. 9 and 10. All the easurements are carried out using Vector Network Analyzer (VNA) Agilent N5 230A.The agreement between the simulated and measured data is reasonably good. The discrepancy between the measured and simulated results is due to the effect of improper soldering of SMA connector or fabrication tolerance. 


# Conclusion

A single feed single layer two L slits microstrip antenna has been proposed in this paper. It is shown that the proposed antenna can operate in four frequency bands. The slits reduced the size of the antenna by 71.14 % for the resonant frequency 2.16GHz and increase the bandwidth up to 48.56 MHz with a return loss of -30.6 dB and 3 dB beamwidth of 166.82 deg. An optimization between size reduction with multiband operation is maintained in this work.
1![Fig.1: Antenna 1 Configuration Fig. 2 : Antenna 2 Configuration](image-2.png "Fig. 1 :")
![and fig 4 respectively. MHz respectively. In conventional antenna return loss found of about -17.77 dB at 3.42 GHz and corresponding bandwidth is 50.54 MHz. Due to the presence of slot at the edge of the patch of antenna 2 multi frequency operation is obtained with large values of frequency ratio. For antenna 2 return losses -23.4 dB is obtained at 2.16 GHz, -15.2 dB at 2.68 GHz,-30.6 dB at 3.22GHZ and -20.3 dB at 4.37 GHz and corresponding 10 dB bandwidth is 11.02 MHz, 13.07 MHz, 35.86 MHz and 48.56 MHz respectively.](image-3.png "")
345678![Fig. 3: Simulated return loss of the antenna1 Fig. 4: Simulated return loss of the antenna2 The simulated E plane and H plane radiation patterns for antenna 2 are shown in Figure 5-8.](image-4.png "Fig. 3 : 4 :Fig. 5 :Fig. 6 :Fig. 7 :Fig. 8 :")
9![Fig. 9 : Comparison between measured and simulated return losses for antenna1](image-5.png "Fig. 9 :")
			© 2012 Global Journals Inc. (US)
		
		
			

## Return loss in dB


## Frequency in GHz
Simulated Result Measured Result			
			

				


* 
	
		Small planar monopole Antenna with a shorted parasitic inverted-L wire for Wireless communications in the 2.4, 5.2 and 5.8 GHz bands
		
			JYJan
		
		
			LCTseng
		
	
	
		IEEE Trans. Antennas and Propag
		
			52
			7
			
			July 2004
		
	




* 
	
		A Compact L-slot Microstrip Antenna for Quad band Applications in Wireless Communication
		
			UChakraborty
		
		
			BMazumdar
		
		
			SKChowdhury
		
		
			AKBhattacharjee
		
	
	
		Global Journal Of Researches in Engineering (F)
		
			Feb,2012
		
	
	XII Issue II Version I




* 
	
		Dualband monopole antenna with L-shaped strips for 2.4/5 GHz WLAN applications
		
			J.-HGu
		
		
			SSZhong
		
		
			LLXue
		
		
			ZSun
		
	
	
		Microwave Opt. Technol. Lett
		
			50
			
			2008
		
	




* 
	
		Compact wideslot tri band antenna for WLAN/WIMAX applications
		
			QZhao
		
		
			SXGong
		
		
			WJiang
		
		
			BYang
		
		
			JXie
		
	
	
		Progress In Electromagnetics Research Letters
		
			18
			
			2010
		
	




* 
	
		Microstrip Antenna Design Handbook
		
			GRamesh
		
		
			PBhartia
		
		
			IBahl
		
		
			AIttipiboon
		
		
			2001
			Artech House Inc
			Norwood, MA
		
	




* 
	
		Equations for Microstrip Circuit De-sign
		
			EOHammerstad
		
	
	
		Proc. Fifth European Microwave Conf
				Fifth European Microwave Conf
		
			September 1975
			
		
	




* 
	
		Advanced Engineering Electromagnetic
		
			CABalanis
		
		
			1989
			John Wiley & Sons
			New York
		
	




* 
	
		
		Zeland Software Inc. IE3D: MOM-Based EM Simulator