# I. Introduction ear-end car collision typically occur in traffic situation with dense traffic and relatively small distances between vehicles in the small lane. Rear-end collisions often result in neck injuries to the occupants of the struck car. During the collision the vehicle is subjected to a forceful forward acceleration and the car occupants are pushed forward by the seatbacks. The head lags behind due to its inertia forcing the neck into a swift extension (rearward binding) motion. This head motion continues until the neck reaches the end of its motion range or, hits a head restraint or some other structure behind the head. From this point on, the head moves forward and stops in a somewhat flexed (forward bent) neck posture. This type of swift injurious extension-flexion motion of the neck (1, 2) and is commonly called "Whiplash motion". Neck injuries in rear-end collisions mostly occur at very low impact velocities, typically less than 20 Km/h (3,4) and are mostly classified as minor injury (AIS 1) on the abbreviated injury scale (5,6,7) since the scale classifies injuries according to fatality risk. (8) suggested that the elastic rebound of the seat back could be an aggravating factor for the whiplash extension motion. The rebound of the seat back can push the torso forward relative to the vehicle at an early stage of the whiplash extension motion when the head begins rotating rearward. This in turn increases the relative linear and angular velocity of the head relative to the upper torso at the same time as it delays contact between the head and head-restraint, thus causing a larger maximum extension angle. Subsequent studies support this theory (9,10). If the seat back of the front seat collapse or yields plastically during a rear-end collision, the elastic seat back rebound is likely to be reduced. To date, the underlying injury mechanism has not yet been established. Several hypotheses have been suggested by various researchers, but are not conclusive. It seams to be generally agreed upon the fact that such injury is related to sudden movement of the head-torso complex (11). # II. Seat Design for Wad Mitigation Several seat systems are presented to prevent whiplash injury. Volvo presented the WHIPS seat (12) which is equipped with a recliner that allows controlled backward movement of the backrest during rear-end impact. The motion is performed in two steps: a translational rearwards movement of the backrest is followed by a rotational motion reclining the backrest. Another system, called WipGARD (13), also enables the backrest to perform a translation followed by a rotation. Both the WHIPS and the WipGARD require a critical load to activate the system. The Saab active head restraint (SAHR) system ( 14), for instance, consists of an active head restraint that automatically moves up and closer to the occupant's head in rear-end impacts. Thus the distance between the head restraint and the head is reduced. The third system is Cervical Spine Distortion injuries (CSD), and the functional principle of the CSD system is based on a defined energy absorption in the backrest. This principle has been employed successfully for a number of years. In standard series seats, the deformation element is located in the recliner. During rear impact, a parallel backwards movement of the seat back begins at a point of critical load, which motion is then transformed into rotation (15). The backwards movement is limited so that the seat back will offer sufficient protection in a high-speed rear impact. # III. Drop Damping Seat The Drop Damping Seat (DDS) proposal was to develop a mechanism which can be attached to production car seats to reduce the relative motion between the head and lower end of the neck. As stated in the literature [17,18,19] this will reduce the risk of this problem by limiting rearward movement but permitting vertical movement to increase the efficiency of whiplash reduction system. The DDS contains four linkages attached to the seat base and the trolley (car floor). During a change in motion of a vehicle, they provide for a change in position of the seat in the form of rotational dropping movement in a generally backward direction opposite the direction of move of the car (Figure 1). As the seat and the occupant of the seat move rearward relative to the car, the head of the occupant accelerates over a longer time. The design was found to work in a satisfactory manner, without the risk of the seat pivoting rearward as in a standard motor vehicle seat. Figure 1 : Drop damping seat during rear-end impact Different vehicle protection systems have been proposed including those dependent on inertia and those with power drive. Inertia type devices are reactive to inertial forces. Power-derived safety devices have many disadvantages. They require that a sensor react to an event and start an action. Such requirements need exact timing and can fail to perform within the time period available, or at least can fail to perform soon enough for the device to do its job within that period of time. Also, power-operated safety devices are very costly and have a number of mechanisms that can fail. By contrast, on vehicle impact, the DDS reacts completely to the inertia of the vehicle seat to begin its action, the device functions instantly in reaction to the shock force of a rear-end impact. The present device is not expensive and has only a few parts and as well it is maintenance free (Figures 2 and 3). The DDS generates a movement of the seat that dissolves the backward energy of the occupant by moving the occupant downward as well as rearward. This movement increases both the distance and time of travel of the occupant and reduce the head acceleration, and there is minimum head snap or whiplash injury. The seat motion is controlled by four identical linkages with pivotal connections between the trolley (vehicle floor) and seat base frame. The initial linkage angles should be less than 90 o to insure the rearward and downward motion (not rearward and upward as would occurs if the angle is more than 90 degree) Figure 2. One target is that the DDS start motion of the seat at the instant acceleration of the rearend impact begins. An additional objective is that the DDS maintains the controlled seat motion for the length of acceleration of the occupant. During rear-end impact, the both rearward and downward movements of the DDS were occurred. The results for the head acceleration peak values are 2.5 g at 120 ms, 9 g at 131 ms and 14 g at 129 ms as shown in Figures 5-34, 5-35 and 5-36. These figures also compare the DDS with the RS and LDS results. The results indicate major head acceleration reductions by using the DDS for the same sled conditions with respect to RS and LDS. Figure 5-37 summaries the head acceleration results for RS, LDS and DDS, and shows that the amount of head acceleration ranges from 47 % up to 64 % with respect to RS. This significant reduction was due to the energy absorbed by the DDS system. # V. Experimental Results In general the DDS results show a significant reduction in the head acceleration peaks for all sled test results. Also the gradual rise of the head acceleration as shown (Figures 4, 5 # VI. Conclusions The new Drop Damping Seat design for reduction in whiplash injuries, allows less motion between head and torso as shown in the experimental results (trail sled tests), linear damper shows lessen the movement of the neck (spring) extension. A comparison between three cases is created to show the effect of DDS on reducing the neck acceleration during impact. 2![Figure 2 : Schematic drawing of the linkage arrangement](image-2.png "Figure 2 :") 3![Figure 3 :](image-3.png "Figure 3 :") 4![Figure 4 : Test results comparison between RS, LDS and DDS with seat at 14km/h-4 g](image-4.png "Figure 4 :") 56![Figure 5 : Test results comparison between RS, LDS and DDS with seat at 18km/h-4 g](image-5.png "Figure 5 :Figure 6 :") ![and 6) are due to the kinematic motion of the DDS.](image-6.png "") 7![Figure 7 : Sled test head acceleration peaks results comparison between LDS, DDS, and RS (with seat)](image-7.png "Figure 7 :") Author ? ? ? ?: © 2014 Global Journals Inc. (US) * Injury Frequency and Head Restraint Effectiveness in Rear End Impact Accidents JDStates JCBalcerak Proceedings of the 16 th Stapp Car Crash Conference the 16 th Stapp Car Crash Conference * MIDetroit 1972 * Analysis of Human Test Subject Kinematic Responses to Low Velocity Rear End Impacts WEMcconnell RPHoward Vehicle and Occupant Kinematics: Simulation and Modelling. Society of Automotive Engineers, SAE Special Publication SP-975 1993 Paper No. 930889. * An Evaluation of Head Restraints -Federal Motor Vehicle Safety Standard 202. NHTSA Technical Report, DOT HS-806 108, National Technical Information Service CJKahane 1982 Springfield, Virginia 22161, USA * An in-Depth Study of Neck Injuries in Rear-End Collisions IOlsson OBunketorp Proc. 1990 Int. IRCOBI Conf. on the Biomechanics of Impacts 1990 Int. IRCOBI Conf. on the Biomechanics of ImpactsBron, Lyon, France 1990 * Influence of the Seat and Head Rest Stiffness on the Risk of Cervical Injuries in Rear Impact JYForet-Bruno FDauvilliers Proc.13 th ESV Conf .13 th ESV ConfParis, France; NHTSA, USA, DOT HS 1991 807 991 * Occupant Protection in Rear-End Collisions: 1. -Safety Priorities and Seat Belt Effectiveness MBJames CEStrother Proc. 35th 35th * Stapp Car Crash Conf., SAE/P-91/251, SAE paper no 912913 1991 * Influences of the Physical Parameters on the Risk to Neck Injuries in Low Impact Speed Rear-End Collisions KOno MKanno Int. IRCOBI Conf. on the Biomech. Of Impacts Eindhoven, The Netherlands Sept. 8-10. 1993 * The Enigma of Whiplash Injuries JDStates MWKorn Proc. 13th AAAM 13th AAAM 1969 * The Dynamic Behavior of the Head and Cervical Spine During Whiplash JAMckenzie JFWilliams J. Biomech 4 1971 * Low Speed Rear Impacts and the Elastic Properties and Automobiles DPRomilly RWTomson PROC. 12th Int. ESV Conf 2014 US Year * Drop Damping Seat to Reduce Whiplash Injury in Rear-end Collision Department of Transp NHTSA, USA 1989 * The Whiplash Encyclopedia RFerrari 1999 Aspen Publishers Inc Gaithersburg, PA * Relationships between Passenger Car Seat Back Strength and Occupant Injury Severity in Rear End Collisions: Field and Laboratory Studies PPrasad AKim Proceedings of the 41 st Stapp Car Crash Conference the 41 st Stapp Car Crash Conference 1997 * Low Speed Rear Impacts and the Elastic Properties and Automobiles' DPRomilly RWTomson PROC. 12 th Int. ESV Conf 1989 US Department of Transp., NHTSA, USA * Influence of the Seat and Head Rest Stiffness on the Risk of Cervical Injuries in Rear Impact JYForet-Bruno FDauvilliers 1991 * Proc.13th ESV Conf .13th ESV ConfParis, France; NHTSA, USA, DOT HS 807 991 paper 91-S8-W-19 * The Whiplash Encyclopedia RFerrari 1999 Aspen Publishers Inc Gaithersburg, PA * Occupant Protection in Rear-End Collision?: The Role of Seat Back Deformation in Injury Reduction'. Society of Automotive Engineers CYWarner CEStother 1991 SAE Paper No. 912914 * An Analytical Approach to the Impact Biomechanics of Head and Neck Injury BAldman Proceedings 30th Annual AAAM Conference 30th Annual AAAM Conference 1986 * A Comparison of Active Head Restraints for Neck Protection in Rear-End Collision DBigi AHeilig 1998 Austria University of Technology Graz Paper No. 98-S5-O-15 * Neck Injury Prevention in Rear-Impact Crashes CDippel MMuser Proceedings of the International IRCOBI Conference on the Biomechanics of Impacts the International IRCOBI Conference on the Biomechanics of Impacts 1997